Velotric Breeze 1 Fender

Printed instructions would have been far better. If the person in the video had clearly shown which screws were being used, the process would have been much easier to follow. Here are a few tips:

The silver plate goes on the inside of the fender. Use the screws without washers for this step.

When attaching the plastic holder for the rod, do not fully tighten it at first. Attach it loosely so the rod brace has some room to move. As you connect all of the mounting points, keep in mind that there are two screws on the sides, one on each side. Loosening these allows you to move the fender in or out, which helps you set the correct clearance between the fender and the tire. Leaving a little play in the plastic holder also helps you center the fender properly. Once everything is aligned, tighten all of the screws. The key point is that the two side screws control the in-and-out adjustment of the fender rods.